ELO Serial/USB Controller for Intellitouch and Securetouch

Item No: D68054-000


€ 108,10 Each
€ 91,95 10+
€ 85,45 20+


Out Of Stock




Add To Cart
Description

  • Elo controller for Intellitouch and securetouch
  • Supply Voltage and Current
  • •+5 VDC, nominal (+4.75 to +5.25 VDC)
  • •Operating current 75mA, maximum at +5 VDC. Typical power dissipation is 300mW at 5V
  • •Inrush current of up to 600mA for 50mS following power on
  • •Supply must be capable of sourcing 200 mA, minimum
  • •Total noise and ripple requirement must be less than 100 mV (p-p) for frequencies below 1 MHz, and less than 50 mV (p-p) for frequencies above 1 MHz
  • Serial Interface
  • •EIA 232E (Serial RS-232), DCE configuration. 8 Data Bits, 1 Stop Bit, No Parity, Full Duplex
  • •Hardware handshaking: RTS/CTS
  • •DSR is pulled HIGH (>+3V) by the 2701RSU when connected and powered. DTR can be asserted by the host to interrupt the flow of data from the controller
  • •Note that if the application does not monitor CTS, then an interval of approximately 5 seconds should be inserted between the issuance of a reset command and any other command
  • Baud Rate
  • •9600 (default) and 19200
  • USB Interface
  • •The CTR-270100-IT-RSU-00R controller is an interrupt-type, full-speed USB device
  • Operating Modes
  • •Full IntelliTouch SmartSet protocol
  • •Customer specific protocol
  • •Initial/ Stream/ Untouch Modes
  • Touch Resolution
  • •4096x4096, size independent
  • Conversion Time
  • •Approximately 10 ms per coordinate set
  • Reliability
  • •MTBF greater than 1,543,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for ground benign environment with an ambient temperature of 25°C
  • Supplied without cables